Nsf - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
68 Confidential and Proprietary Information of ZTE CORPORATION
always
metric <metric-val
ue>
metric-type <type>
route-map
<map-tag>
There is no default route obtained from other route protocol or
static configuration.
This command is supported after the platform version 4.6.02.
No matter whether local router has default routes or not, there will
an advertisement of a default route. The cost of the default route
is 20. The type of the default route is ext-1. The used route-map
is map.
ZXR10(config)#router ospf 1
ZXR10(config-router)#notify default route always metric 20
metric-type ext-1 route-map map

nsf

Use this command to configure the function of Non-stop Forward-
ing.The use of the no form of this command indicates that the
function is not supported.
Router configuration

nsf

no nsf
There is no function of Non-stop Forwarding.
� This command is supported after the platform version 4.6.03B.
Tip:
Make sure that the running OSPF cases support Opaque LSA before
the use of this command.
In this example, local device has the function of non-stop forward-
ing.
ZXR10(config)#router ospf 1
ZXR10(config-router)#nsf
The specification of always shows that the
default route will be advertised no matter
whether it exists. If there is no specification
of always, the advertisement of the default
route depends on whether the default route
exists in the routing table. If the default route
exists, it will be advertised, vise versa
Metric of the default route, range:
0~16777214,default: 1
Type of the default route, ext-1 or ext-2,
default: ext-2
Name of the route map generating the default
route, 1~16 characters