Isis Network Point-To-Point; Isis Priority - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related Command
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
112 Confidential and Proprietary Information of ZTE CORPORATION

isis network point-to-point

Use this command to configure isis protocol LAN to simulate point-
to-point function. Use no to delete this configuration.
Interface configuration mode

isis network point-to-point

no isis network point-to-point
Isis works at broadcast interface mode.
This command is suitable for the condition where there are only
two devices. The command is configured to enable LAN to simulate
point-to-point function.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis network point-to-point
show running-config

isis priority

Use this command to configure the priority of DIS election of the
interface. Restore default with the no form of this command.
Interface configuration
isis priority <priority>[level-1 | level-2]
no isis priority [level-1 | level-2]
<priority>
level-1
level-2
If level-1 or level-2 is not specified, this command acts at both
level-1 and level-2 at the same time.
The parameter of level is not valid on point-to-point mode simu-
lated by LAN.
This command only appears on a broadcast link.
This command can be configured but not valid when point-to-point
is simulated by LAN.
This example describes configures the priority of DIS election of
the interface.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis priority 20
ZXR10(config-intf)#isis priority 20 level-1
ZXR10(config-intf)#isis priority 20 level-2
of the interface, range: 0~127, default: 64
The router is in area Level-1.
The router is in area Level–2.