Area Authentication - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
32 Confidential and Proprietary Information of ZTE CORPORATION
mpls traffic-eng area..........................................................63
mpls traffic-eng router-id....................................................64
neighbor ..........................................................................64
network ...........................................................................65
no area ............................................................................67
notify default route ............................................................67
nsf ..................................................................................68
passive-interface ...............................................................69
redistribute.......................................................................69
router ospf .......................................................................71
router-id ..........................................................................72
show ip ospf .....................................................................72
show ip ospf border-lfas .....................................................74
show ip ospf border-routers ................................................75
show ip ospf database........................................................76
show ip ospf interface ........................................................86
show ip ospf mpls traffic-eng link.........................................88
show ip ospf neighbor ........................................................89
show ip ospf nsf ................................................................91
show ip ospf request-list.....................................................92
show ip ospf retransmission-list...........................................93
show ip ospf virtual-links ....................................................93
summary-address..............................................................94
timers lsa-group-pacing .....................................................95
timers spf.........................................................................95

area authentication

Use this command to enable the authentication in the OSPF area.
Disable the authentication with the no command.
Router configuration
area <area-id> authentication [message-digest]
no area <area-id> authentication [message-digest]
<area-id>
message-digest
There is no authentication by default.
� This command is supported after the 4.6.02 platform version.
�
If there is no parameter, the type 1 (simple password ) au-
thentication will be used. If there is a parameter , the type 2
(message digest) authentication will be used.
� If the area does not exist, it will be created automatically.
This example uses type 2 authentication on area 1.
ZXR10(config)#router ospf 1
ZXR10(config-router)#area 1 authentication message-digest
Area identifier, a decimal number
(0~4294967295) or a dotted decimal IP
address
Use the type 2 (message digest)
authentication in the area