Isis Authentication; Isis Authentication-Type - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example

isis authentication

Use this command to configure the authentication of ISIS hello
PDUs. Delete the authentication with the no form of this com-
mand.
Interface configuration
isis authentication <key>[level-1 | level-2]
no isis authentication [level-1 | level-2]
<key>
level-1
level-2
If level-1 or level-2 is not specified, this command acts at level-1
and level-2 at the same time.
This example configures the authentication of hello PDUs.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis authentication zte
ZXR10(config-intf)#isis authentication zte level-1
ZXR10(config-intf)#isis authentication zte level-2

isis authentication-type

Use this command to set the authentication type of IS-IS hello
PDUs. To delete the configuration of the corresponding level, use
the no form of this command. TEXT authentication is enabled by
default.
Interface configuration
isis authentication-type {MD5 | TEXT}[level-1 | level-2]
no isis authentication-type [level-1 | level-2]
MD5
TEXT
level-1
level-2
TEXT authentication is enabled by default.
If level-1 or level-2 is not specified, this command acts at level-1
and level-2 at the same time.
This example sets the authentication type of IS-IS hello PDUs.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis authentication-type MD5
Confidential and Proprietary Information of ZTE CORPORATION
Password, 1~30 characters
Router are in area Level-1
Routers are in area Level-2.
MD5 encrypted authentication
TEXT authentication
Routers are in area Level-1.
Routers are in area Level-2.
Chapter 4 IS-IS Protocol
105