Router-Id; Show Ip Ospf - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
72 Confidential and Proprietary Information of ZTE CORPORATION

router-id

Use this command to specify the router identifier of an OSPF
process. Delete the specified router identifier with the no form of
this command.
Router configuration
router-id <ip-address>
no router-id
<ip-address>
An OSPF process uses the OSPF router identifier selected automat-
ically.
� This command is supported after the platform version 4.6.02.
� The configuration of this command makes the OSPF process
use the OSPF router identifier in the form of a specified IP ad-
dress. The no command of this command makes the OSPF
process use the OSPF router ID selected automatically.
� This configuration takes effect after the restart of the router or
the manual restart of the OSPF process. The OSPF is manually
restarted with the clear ip ospf process command.
This example configures the router-id of local router as 5.5.5.5.
ZXR10(config)#router ospf 1
ZXR10(config-router)#router-id 5.5.5.5
ZXR10(config-router)#end
ZXR10#clear ip ospf process 1

show ip ospf

Use this command to show the summary information of OSPF pro-
tocol and that of each OSPF area.
All modes
show ip ospf [<process-id>]
<process-id>
This command is supported after the platform version 4.6.02.
Examples of the displaying information (the data below is for ref-
erence only) :
� If the OSPF protocol has not yet been started, there will be the
following information of system prompt.
ZXR10#show ip ospf
There is no OSPF instance
OSPF router identifier, in the form of IP
address
OSPF process ID, range: 1~65535