Domain-Tag; Enable Area - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
50 Confidential and Proprietary Information of ZTE CORPORATION
router ospf x

domain-tag

Use this command to specify OSPF domain tag.
Router configuration
domain-tag <tag-value>
<tag-value>
�
This command is supported after the platform version 4.6.03.
� If the domain-tag command has been configured, when BGP
is redistributed, the generated tag value of the external LSA is
the configured tag-value. When unnecessary route loop avoid-
ing filtering appears, this command can be used to modify the
tag value of one PE, and then there will be no route loop avoid-
ing filtering on another PE.
This example designates 1200 as local domain-tag.
ZXR10(config)#router ospf 1
ZXR10(config-router)#domain-tag 1200
redistribute

enable area

Use this command to enable the specified area if it exists.
Router configuration
enable area <area-id>
<area-id>
If this area has been configured, it is enabled by default.
This command is supported after the platform version 4.6.02.
This example describes enables area 1.
ZXR10(config)#router ospf 1
ZXR10(config-router)#enable area 1
Range of domain-tag: 1~4294967295
Area identifier, a decimal value
(0~4294967295) or a dotted decimal
IP address