Maximum-Paths; Neighbor - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
20 Confidential and Proprietary Information of ZTE CORPORATION
with the packet switching network), the split horizon must be
disabled for all the routers and access servers in the related
multicast groups of the network.
� In the network including the links of X.25 switching network,
the neighbor command can be used to change the features of
split horizon. And the no ip split-horizon command can be
definitely specified as the replacement of it in the configuration.
If so, the split horizon, however , must be disabled for all the
routers in the related multicast groups of the network.
This example describes how to disable the split horizon mechanism
in the serial link.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#no ip split-horizon

maximum-paths

Use this command to configure the number of routes the load bal-
ance supports. Make it restore 1 with the no form of this com-
mand.
Router configuration
maximum-paths <number>
no maximum-paths
<number>
The default value of the parameter <number> is 1.
The number of the same effective routes received through RIP pro-
tocol can be adjusted according to the requirements of the load
balance.
This example changes the number of path the load balancing sup-
ports into 2.
ZXR10(config)#router rip
ZXR10(config-router)#maximum-paths 2

neighbor

Use this command to define the adjacent routers that exchange
route information with local router. Delete the adjacent routers
with the no form of this command.
Router configuration and address family configuration
neighbor <ip-address>
no neighbor <ip-address>
Number of routes load balance supports,
range: 1~8, default: 1