Mpls Traffic-Eng Area - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
<seconds>
There is no function of preventing black hole of routes.
� This command is supported after the platform version 4.8.01.
� If this command takes effect, the transit-link of local router-lsa
will be set as 65535.
� If the option on-startup is configured, it will take effect only
after the restart of rack or OSPF.
� The configuration of on-startup wait-for-bgp shows that, if
60 seconds after BGP's converge or the default wait time (600
seconds) expires, LSA will restore normalness and no more be
set as 65535.
� The configuration of on-startup <5~86400> shows that, LSA
restores normalness and is no more set as 65535 after the
expiration of the wait time.
This example specifies the wait time after the restart to prevent
black hole of routes as 50 seconds.
ZXR10(config)#router ospf 1
ZXR10(config-router)#max-metric router-lsa on-startup 50

mpls traffic-eng area

Use this command to enable the equipment to support the gener-
ation of its own TE information and flood it to the specified area.
Router configuration
mpls traffic-eng area <area-id>
no mpls traffic-eng area <area-id>
<area-id>
This command is not supported.
� This command is supported after the platform version 4.6.02.
� If it is necessary to support traffic engineering in some area,
this command must be configured.
This example sets OSPF area 1 to support traffic engineering.
ZXR10(config)#router ospf 1
ZXR10(config-router)#mpls traffic-eng area 1
Confidential and Proprietary Information of ZTE CORPORATION
Time for continually preventing black hole of
routes after restart, range: 5~86400
Area identifier, a decimal value
(0~4294967295) or a dotted decimal
IP address
Chapter 3 OSPF Protocol
63