Isis Mesh-Group; Isis Metric - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example

isis mesh-group

Use this command to configure the mesh-group function of IS-IS.
Delete the function with no form of this command.
Interface configuration
isis mesh-group {<mesh group number>| block}
<mesh group
number>
block
This command is supported after the platform version 4.8.02.
This example configures the mesh-group of IS-IS.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis mesh-group ?
<1-4294967295> Mesh group number
blocked Block LSPs on this interface

isis mesh-group

no isis mesh-grou

isis metric

Use this command to configure the metric value of this interface.
Restore default with no form of this command.
Interface configuration
isis metric <metric-value>[level-1 | level-2]
no isis metric [level-1 | level-2]
<metric-value>
level-1
level-2
If no level-1 or level-2 is not specified, this command acts on both
level-1 and level-2 at the same time.
If it is the metric-style narrow, the range of the <metric-value>
will be 0~63. If it is the metric-style wide mode, the range of the
<metric-value> will be 0~426142864.
This example configures the metric value of this interface.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis metric 20
ZXR10(config-intf)#isis metric 20 level-1
ZXR10(config-intf)#isis metric 20 level-2
Confidential and Proprietary Information of ZTE CORPORATION
Mesh-group the interface belongs to
LSP information is blocked on the interface
Metric value of the interface, range:
0~16777214, default: 10
The router is in area Level-1
The router is in area Level-2
Chapter 4 IS-IS Protocol
111