ZXR10 8900 Series Command Reference (IP Routing Volume I)
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
108
Confidential and Proprietary Information of ZTE CORPORATION
This example describes sets the time interval of sending Hello
packets.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis hello-interval 5
ZXR10(config-intf)#isis hello-interval 5 level-1
ZXR10(config-intf)#isis hello-interval 5 level-2
isis hello-multiplier
Use this command to configure the hello multiplier value of the in-
terface. This value is the number of successive IS-IS Hello packets
a neighbor must miss before the networking device should declare
the IS-IS adjacency as down.
Therefore, the "holding time" of the adjacency relationship is the
hello-interval multiplied by the hello-multiplier. Restore default
with the no form of this command.
Interface configuration
isis hello-multiplier <multiplier>[level-1 | level-2]
no isis hello-multiplier [level-1 | level-2]
<multiplier>
level-1
level-2
If level-1 or level-2 is not specified, this command acts at both
level-1 and level-2 at the same time.
The parameter of level is not valid on point-to-point mode simu-
lated by LAN.
This example configures the hello-multiplier.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis hello-multiplier 2
ZXR10(config-intf)#isis hello-multiplier 2 level-1
ZXR10(config-intf)#isis hello-multiplier 2 level-2
isis ignore-mtu
When the receiving MTU in IS-IS packets is higher than that of the
incoming interface, the check of the length of the packets will be
ignored as long as the packets could be received.
Interface configuration
isis ignore-mtu
no isis ignore-mtu
Multiplier, range: 3~1000, default: 3
Routers are in area Level-1
Routers are in area Level-2