Ip Rip Send Version; Ip Split-Horizon - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions

ip rip send version

Use this command to specify the RIP version sent on the interface.
Restore to the global version configuration status with the no form
of this command.
Interface configuration
ip rip send version {1 | 2 {broadcast | multicast}}
no ip rip send version
1
2
broadcast
multicast
It depends on the router command version.
The use of this command can ignore the RIP default status speci-
fied by the version command, but it only applies for the configured
interfaces.
This example specifies the interface fei_1/1 to send the RIP version
1 packets and version 2 multicast packets.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip send version 1
ZXR10(config-if)#ip rip send version 2 multicast

ip split-horizon

Use this command to enable the split horizon mechanism. Cancel
the split horizon mechanism with the no form of this command.
Interface configuration

ip split-horizon

no ip split-horizon
The split horizon mechanism is enabled.
� Generally, it is not recommended to change the default status
of the command ip split-horizon, unless because of the cor-
rect route advertisement it has no choice but to change the
default satus in the application system. If the split horizon is
disabled on the serial interface (and the interface is connected
Confidential and Proprietary Information of ZTE CORPORATION
The interface only sends the packets of RIP
version 1.
The interface only sends the packets of RIP
version 2. When it is version 2, the broadcast
or multicast mode can be chosen.
The interface sends the compatible packet
to the broadcast address. All routes are the
classful networks, and the supernet route is
not sent.
The interface sends the packet of version 2
to the multicast address. The subnet route
can be sent depending on auto-summary
command.
Chapter 2 RIP Protocol
19