Spf-Interval; Summary-Address - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Field
System Id
Metric
Next-Hop
Interface
SNPA

spf-interval

Use this command to specify the time interval for calculating SPF.
Restore the default time interval with the no form of this com-
mand.
Router configuration
spf-interval <interval>[level-1 | level-2]
no spf-interval [level-1 | level-2]
<interval>
level-1
level-2
If level-1 or level-2 is not specified, this command acts at both
level-1 and level-2 at the same time.
This example describes how to configure the time interval for cal-
culating SPF as 10 seconds.
ZXR10(config)#router isis
ZXR10(config-router)#spf-interval 10
ZXR10(config-router)#spf-interval 10 level-1
ZXR10(config-router)#spf-interval 10 level-2

summary-address

Use this command to specify the summary address of IS-IS. Delete
the summary address of the specified level with the no form of this
command.
Router configuration
Confidential and Proprietary Information of ZTE CORPORATION
Description
System identifier of the destination IS
Metric of arriving at the destination IS "—"
indicates itself "**" indicates routes of the IS
cannot be calculated
Next-hop IS to the destination IS; "no next
hop" indicates that next-hop IS cannot be
found
Interface of routes forwarding
Securing Networks with PIX and ASA (SNPA)
address of next-hop; P-P interface tag:
"*ppp*"
Time interval in seconds, range: 1~120,
default: 3 seconds
The router is in area level-1
The router is in area level-2
Chapter 4 IS-IS Protocol
129