Ip Ospf Priority; Ip Ospf Resync-Timer - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
60 Confidential and Proprietary Information of ZTE CORPORATION

ip ospf priority

Use this command to set the interface priority. Make the interface
restore default with the no form of this command.
Interface configuration
ip ospf priority <priority>
no ip ospf priority
<priority>
� This command is supported after the platform version 4.6.02.
� The router cannot be DR or BDR when the interface priority is
0.
This example describes sets the interface priority as 10.
ZXR10(config)#interface fei_5/1
ZXR10(config-if)#ip ospf priority 10

ip ospf resync-timer

Use this command to set the dead delay time on the GR (Graceful
Restart) restarter. Cancel the configuration with the no form of
this command.
Interface configuration
ip ospf resync-timer < seconds >
no ip ospf resync-timer
<seconds>
� This command is supported after the platform version 4.6.03.
� After this command is configured on some interface, if the
dead-interval the GR restarter and the GR helper appoints ex-
pires, the restarter will waits for a time set by the resync-timer
again to guarantee GR can accomplish in certain time. This is
comparatively applicable for the rack with lower behavior.
This example sets the corresponding waiting time of GR as 120
seconds.
ZXR10(config)#interface fei_5/1
ZXR10(config-if)#ip ospf resync-timer 120
Interface priority, range: 0~255, default: 1
When an Active/Standby Changeover takes
place, the GR helper sets this time to
guarantee the link against break, unit:
second, range: 1~1800, default: 0