Ip Ospf Bfd; Ip Ospf Cost - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
Purpose
<password>
No password is specified.
� This command is supported after the platform version 4.6.02.
� The valid characters for the parameter <password> are as fol-
lows:
0123456789abcdefghijklmnopqrstuvwxyz_ABCDEFGHI-
JKLMNOPQRSTUVWXYZ`*-=~!@#$%^&()_+[]{}|;':,./<>\\
This example sets zxr10 as the password of the interface with sim-
ple password authentication.
ZXR10(config)#interface fei_5/1
ZXR10(config-if)#ip ospf authentication-key zxr10

ip ospf bfd

Use this command to enable OSPF BFD function on some interface,
and it must be an OSPF interface. Cancel this setting with the no
form of this command.
Interface configuration
ip ospf bfd [disable]
no ip ospf bfd [disable]
Some OSPF interface does not support BFD.
� This command is supported after the platform version 4.8.01.
� The ip ospf bfd disable and ip ospf bfd commands cannot
be configured at the same time, because they are mutually
exclusive. So when you configure one of the two commands,
if the other one has been configured yet, you must cancel the
other one with the no command.
� The command ip ospf bfd disable is the supplement of the
command bfd-all-interface. On the premise of bfd-all-in
terface, use ip ospf bfd disable command to make some
specified interface not support BFD function.
This example specifies an interface to support BFD function.
ZXR10(config)#interface fei_5/1
ZXR10(config-if)#ip ospf bfd
bfd-all-interface

ip ospf cost

Use this command to illustrate the interface cost explicitly. Restore
default with the no form of this command.
Confidential and Proprietary Information of ZTE CORPORATION
Authentication password, 1~8 characters (not
including Space)
Chapter 3 OSPF Protocol
55