Show Ip Ospf Border-Routers - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
show ip ospf border-lfas [process <process-id>]
process <process-
id>
This command is supported after the platform version 4.8.20.
This example displays the information of OSPF process 1.
ZXR10(config)#show ip ospf border-lfas process 1

show ip ospf border-routers

Use this command to show internal OSPF route to Area Border
Router (ABR) and Autonomous System Border Router (ASBR).
All modes
show ip ospf border-routers [process <process-id>]
process <process-
id>
This command is supported after the platform version 4.6.02.
This example displays the information of OSPF process 1.
ZXR10#show ip ospf border-routers process 1
OSPF Router with ID (10.10.2.2) (Process ID 1)
OSPF internal Routing Table
Destination Next Hop
160.89.97.53 144.144.1.53
160.89.103.51 160.89.96.51
160.89.103.52 160.89.96.51
160.89.103.52 144.144.1.53
The displayed information is described below
Field
Destination
Next Hop
Cost
Type
RteType
Area
Confidential and Proprietary Information of ZTE CORPORATION
OSPF process ID, 1~65535
OSPF process ID, range: 1~65535
Cost Type RteType
10 ABR INTRA
10 ABR INTRA
20 ASBR INTER
30 ASBR INTER
Description
Router ID of the receiving end
Next-hop to the receiving end
Path cost
Router type of the receiving end. ABR,
ASBR, or both
Path type. It may be the path of an
internal or external area
Area ID obtaining the path
Chapter 3 OSPF Protocol
Area
0.0.0.3
0.0.0.3
0.0.0.3
0.0.0.3
75