ZXR10 8900 Series Command Reference (IP Routing Volume I)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
98
Confidential and Proprietary Information of ZTE CORPORATION
show isis nsf ................................................................... 127
spf-interval ..................................................................... 129
summary-address............................................................ 129
system-id ....................................................................... 130
area
Use this command to configure the area address of IS-IS. Delete
the configuration with the no form of this command.
Router configuration
area <area-address>
no area <area-address>
<area-address>
At most 3 area addresses can be configured.
This example sets the area address of IS-IS.
ZXR10(config)#router isis
ZXR10(config-router)#area 11
ZXR10(config-router)#area 11.1111.1111
authentication
Use this command to configure LSP authentication of IS-IS. Delete
the configuration with the no form of this command.
Router configuration
authentication <key>[level-1 | level-2]
no authentication [level-1 | level-2]
<key>
level-1
level-2
If level-1 or level-2 is not specified, this command acts on both
level-1 and level-2 at the same time.
Area address, a hexadecimal string of 1~13
bytes
Password, length: 1~180 characters
Area Level-1 the router lies in
Area Level-2 the router lies in