Zte ZXR10 8900 Series Command Reference Manual page 76

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
66 Confidential and Proprietary Information of ZTE CORPORATION
Router configuration
network <ip-address><wildcard-mask> area <area-id>
no network <ip-address><wildcard-mask> area <area-id>
<ip-address>
<wildcard-mask>
<area-id>
The network to be configured does not belong to any area.
1. This command is supported after the platform version 4.6.02.
2. Define interfaces running OSPF protocol and area IDs of these
interfaces. If the area does not exist, it will be created auto-
matically.
3. If the interface IP address and the value of <ip-address> cor-
responding to the 0 bits of <wildcard-mask> are equal, this
command will be called to be valid for this interface IP address.
If multiple network commands are valid for the same interface
IP address, the OSPF interface corresponding to the interface
IP address will be created and appended to the area specified
by the network command with the minimum <wildcard-mas
k>.
If there is network command valid for the interface newly con-
figured with IP address, the OSPF interface corresponding to
this interface IP address will be automatically created, and it
will be added to the area specified by the network command
with the minimum <wildcard-mask> valid for the interface IP
address.
If the interface IP address is deleted, the OSPF interface will
be automatically deleted.
4. The no command is just the reverse operation of the configured
network command. If the corresponding network command
does not exist, the no command will be invalid.
If there is corresponding network valid for ospf interfaces of
an ospf area, these OSPF interfaces will be removed from this
area.
If there is still other network command valid for the IP address
of OSPF interfaces, these ospf interfaces will be appended to
the OSPF area specified by this network command.
If multiple network commands are valid for the same inter-
face, the interface will be added to the OSPF area specified by
the network command with the minimum <wildcard-mask>
If there is no network command valid for the interface, the
OSPF interface will be deleted.
This example sets the interface 10.10.1.1 as an OSPF interface
and places it in area 0.
ZXR10(config)#interface fei_5/1
ZXR10(config-if)#ip address 10.10.1.1 255.255.255.0
ZXR10(config-if)#exit
ZXR10(config)#router ospf 1
IP address in the form of dotted decimal
Wildcard mask in the form of dotted decimal
Area identifier, a decimal value
(0~4294967295) or a dotted decimal
IP address