Is-Isv6 Configuration Example; Single Area Is-Isv6 Configuration Example - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv6 Volume)
St- Command
ep
3
ZXR10(config-if-vlanX)#
level-1-2 | level-2-only}
4
ZXR10(config-if-vlanX)#
<1-65535>[level-1 | level-2]
5
ZXR10(config-if-vlanX)#
<1-65535>[level-1 | level-2]
6
ZXR10(config-if-vlanX)#
<3-1000>[level-1 | level-2]
7
ZXR10(config-if-vlanX)#
8
ZXR10(config-if-vlanX)#
<1-65535>[level-1 | level-2]
9
ZXR10(config-if-vlanX)#
10
ZXR10(config-if-vlanX)#
vel-1 | level-2]
11
ZXR10(config-if-vlanX)#
| level-2]
12
ZXR10(config-if-vlanX)#
<1-65535>[level-1 | level-2]
44 Confidential and Proprietary Information of ZTE CORPORATION
isis circuit-type {level-1 |
isis csnp-interval
isis hello-interval
isis hello-multipiler
isis ignore-mtu
isis lsp-interval
isis max-burst <1-65535>
isis metric <0-16777214>[le
isis priority <0-127>[level-1
isis psnp-interval
IS-ISv6 Configuration
Example
Single Area IS-ISv6 Configuration
Example
Analyze the entire network before configuring IS-ISv6, and then
design the network topology according to the network size,
whether dividing multiple areas is needed, whether multiple
routing protocols are running in the network. The following illus-
trates the basic configuration of IS-IS protocol taking single-area
network as an example, as shown in
Function
This configures IS-ISv6
circuit-type on interface.
This configures CSNP sending
interval on an interface.
This configures Hello message
interval on an interval.
This configures multiplier for
Hello holding time.
This configures ignore-mtu.
This configures LSP
transmission interval on
an interface.
This configures the number
that LSP sends each time.
This configures metric on
interface.
This configures IS-ISv6
priority on interface.
This configures IS-ISv6
sending psnp interval on the
interface.
Figure 7 .