Knife Option; Paper Low Sensor; Printhead Resistance; Micr Option - NCR 7158 Owner's Manual

3-28 Chapter 3: Using the Printer

Knife Option

This function makes it possible to set the Knife Option if it is installed
in the printer. This setting should only be changed if the option is
added or removed.

Paper Low Sensor

Paper Low Sensor setting makes it possible to enable or disable the
paper low sensor for particular printer configurations.

Printhead Resistance

The printhead in the thermal receipt printer can be one of two types.
The printhead resistance setting must match the character (A or B)
stamped on the heatsink in the back of the printhead. This character is
visible by removing the top cover of the printer. Only a trained service
representative may remove this cover. Therefore, under normal use
this setting should be left at the factory default.
Using the Configuration Menu sets the printhead resistance settings.
See "Configuring the Printer" for instructions on how to enter the
Configuration Menu.

MICR Option

This function makes it possible to set the MICR Option if it is installed
in the printer. This setting should only be changed if the option is
added or removed.

Check Flip Option

This function makes it possible to set the Check Flip Option if it is
installed in the printer. This setting should only be changed if the
option is added or removed.