Testing the Printer
The Configuration Menu allows you to set general printer parameters.
The test prints a list of various printer settings and partially cuts the
paper if a knife is installed. The test printouts may vary depending on
the printer model. To change the default settings, enter the
Configuration Menu as instructed on the bottom of the test printout.
The printout may be useful to a service representative if there is a
problem. If something appears to be wrong with the test printout (such
as missing or faded text) additional troubleshooting and diagnostic
guides are available.
1. To run the test, either:
a. Open and close the receipt cover while holding down the Paper
Feed Button,
OR,
b. Press the Paper Feed Button and the Reset Button at the same
time.
2. When the printer begins printing let go of the Paper Feed Button.
Chapter 2: Setup Guide 2-11