Ordering Communication Cables; Forms Specifications - NCR 7158 Owner's Manual

Ordering Communication Cables

Forms Specifications

Contact your sales representative to order the communication cables
listed in the table. The numbers are for reference only. Suppliers may
use other numbers.
Communication Cables
RS-232C 9-pin to 9 pin
RS-232C 9-pin to 9 pin
The prints on single- or multiple-part forms in the slip station (up
7158
to five-part forms). Forms and slips must meet the following
requirements:
•
Front insertion (minimum):
51 mm (2.00 inches) wide
68 mm (2.68 inches) long
•
Side insertion (minimum):
203 mm (8.0 inches) wide
51 mm (2.0 inches) long
•
Single-ply forms should be on paper that is greater than 15 pounds
•
Multiple-part forms (up to five parts) should be no thicker than .40
mm
(.016 inches) and a minimum thickness of .08 mm (.003 inches).
Note: Do not use forms containing holes along the top or right
edge.
•
Forms for use with Flip Check (minimum)
51 mm (2.00 inches) wide
70 mm (2.75 inches) long
Chapter 4: Printer & Media Supplies
Length
(0.7 meters—2 ft.)
(4.0 meters—13 ft.) 1416-C266-0040
4-3
Order Number
1416-C359-0007