Check Flip Test Mode
To run the Check Flip Test Mode:
1. Enable the Check Flip Test Mode through the Configuration Menu
(See "Configuring the Printer," for instructions on how to enter the
Configuration Menu), then exit the Configuration Menu.
2. Insert a check as if validating the check, lengthwise and face down
into the slip station. (See "Verifying and Validating Checks" section
to insert check.)
A check must be used—if any other slip or form is inserted the
printer will not conduct the test.
First Line of
Print Guide
Slip
Table
Chapter 3: Using the Printer 3-25
Check Orientation - Face down
Green
Slip-in LED
Check
Guide
Extended
Slip Table
ENDORSE HERE
MEMO