Select Cut Mode And Cut Paper - NCR 7158 Owner's Manual

7-34 Chapter 7: Programming Guide

Select Cut Mode and Cut Paper

ASCII:
Hexadecimal:
Decimal:
Value of m :
Value of n :
M Feed and Cut Mode
0, 48 Full cut (no extra feed). Partial cut on the 7158.
1, 49 Partial cut (no extra feed).
65 Feeds paper to cutting position + (n times vertical motion unit),
and cuts the paper completely.
66 Feeds paper to cutting position + (n times vertical motion unit),
and performs a partial cut.
Range of m:
Range of n:
Default of n:
Default of m:
Selects a mode for cutting paper and cuts the paper. There are two
formats for this command, one requiring one parameter m, the other
requiring two parameters m and n. The format is indicated by the
parameter m.
Formulas: n times the vertical motion unit is used to determine the
cutting position to which the paper is fed.
Exceptions:
If m is out of the specified range, the command is ignored.
GS V m GS V m n
1D 56 m 1D 56 m n
29 86 m 29 86 m n
Selects the mode as shown in the table
Determines cutting position only if m is 65 or 66.
0, 48; 1, 49
65, 66 (when used with n)
0 - 255
0
0