Enable Or Disable Online Switch; Set Slip Paper Waiting Time - NCR 7158 Owner's Manual

Enable or Disable Online Switch

ASCII:
Hexadecimal:
Decimal:
Value of n :
Since the does not have an Online Switch, this command is
7158
ignored.

Set Slip Paper Waiting Time

ASCII:
Hexadecimal:
Decimal:
Value of m :
Value of n :
Sets the time (in m minutes) that the printer waits for a slip to be
inserted into the slip station. It also sets the time (n x 0.1 seconds) that
the printer waits to close the platen and start printing once the slip has
been inserted. The printer reads that a slip is inserted when the leading
edge and trailing edge sensors are covered. The LED on the slip table is
lit (green) when both sensors are covered.
If a slip is not inserted in the time specified, the receipt station is
selected for the next function. If m = 0, the printer waits forever for a
slip to be inserted. The times set by this command are used only by the
command, Select Receipt or Slip for Printing, Slip for MICR Read (1B
63 30 n), with n set to 04.
ESC c 6 n
1B 63 36 n
27 99 54 n
0, 1
ESC f m n
1B 66 m n
27 102 m n
Minutes
Tenths of seconds
Chapter 7: Programming Guide 7-31