Advertisement

Quick Links

NCR 7150 POS printer

Specifications

Standard Features

• Solenoid retractable platen
• Receipt / Slip / Journal printing
• Bi-directional slip motor
• Power-ON self tests
• Journal take up roll

Optional Features

• Cut-sheet and detector

Print Features

• 9 pin print head
• Bi-directional print direction
• Font select -(7 x 9 or 9 x 9)
• 42 or 46 character per line.
• 200 lines per minute
• Near-end of roll detection switch

Tools Required

• Phillips (xCELITE x100)
• #2 Posi-drive screwdriver
• 5/32" Flat-blade screwdriver
• 5.5 MM Hex Nut driver
• Feeler gauges
• Allen Wrenches
90 Degree,
3/32",
5/64" ,
1.5 MM.

Jumper/Switch Settings

Diagnostic Options
Receipt ASCII Dump
Journal ASCII Dump
Slip ASCII Dump
Knife Cut
Loop On Lever 0
IBM Document: NCR
Page 1 of 2
S4
S3
S2
S1
0
0
0
1
0
0
1
0
0
0
1
1
0
1
0
0
1
1
0
0

Power-On Self Test

Setup For All Tests

• Make sure a ribbon cassette is installed
• Load proper paper for the test you desire in the printer.
• Close all covers on the printer.
• Perform your desired test listed below.

Receipt Paper

• Press Receipt Feed button and hold
• Press the Reset button then release both buttons
• Printer will print a test pattern, check the bi-directional
feed, and if available do a partial and full knife cut.

Journal Paper

• Press Journal Feed button and hold.
• Press the Reset button then release both buttons
• Printer will print a test pattern if paper loaded.

Slip Paper

• Press Receipt and Journal Feed buttons and hold
• Press the Reset button then release all buttons
• Printer will print a test pattern if paper is loaded.
Conclusion For All Tests
• Since the Receipt and Journal print continuously without
stop then the reset button has to be depressed again to
stop the test.

Field Replaceable Units

Description
7150-7001-9001 Printer
Switch-Snap Action
Core - Take Up
Core - Paper Supply
Slip Sensor Assembly
Receipt Guide-Non Knife
Platen Assembly
Print Head
Ribbon Guide
Blade - Tear Off
© Copyright International Business Machines, 1997
NCR Printer
Model 7150
OEM Part
IBM Part
7150-7001-9001
22H3354
006-1050199
22H3355
189-1051983
22H3356
189-1052974
22H3357
189-1053854
22H3358
189-1054915
22H3359
189-1055024
22H3360
189-1055991
22H3361
189-1056571
22H3362
189-0213500
22H3363
05/97 Doc # NCR003
All rights reserved

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7150 and is the answer not in the manual?

Questions and answers

Summary of Contents for NCR 7150

  • Page 1 Receipt Paper • Press Receipt Feed button and hold • Press the Reset button then release both buttons NCR 7150 POS printer • Printer will print a test pattern, check the bi-directional Specifications feed, and if available do a partial and full knife cut.
  • Page 2 Bottom plate for the narrowest slip, the middle plate for the medium slip and top plate for widest slip. • Tighten Allen screw into place and test. IBM Document: NCR 05/97 Doc # NCR003 © Copyright International Business Machines, 1997...

Table of Contents