Generate Tone; Set Column; Open Form (Slip Station); Full Knife Cut - NCR 7156 Owner's Manual

7156 Owner's Guide

Open Form (Slip Station)

Opens the feed roller and platen (forms compensation arm assembly) so that a form may
be inserted (default position).
Hex
18

Full Knife Cut

This command is implemented the same as Partial Knife Cut (1A, 1B 6D). Use either
Hex 19 or Hex 1B 69.
Hex
19
1B 69

Partial Knife Cut

Partially cuts the receipt. The length of the cut can be changed through the DIP switches.
See "Setting Partial Cut Distance" in "Chapter 4: Diagnostics." The default setting leaves
.20 inches (5 mm) of paper on the left edge. The cut edge is 108 dot rows or .71 inches (18
mm) above the receipt print line. The command is valid only at the beginning of a line.
Use either Hex 1A or Hex 1B 6D.
Hex
1A
1B 6D

Generate Tone

Activates a short tone.
Hex
1B 07

Set Column

Prints the first character of the next print line in column n. The command is not valid with
Single or Double Density graphics.
Hex
1B 14 n
Decim ASCII
al
24 CAN
Decima ASCII
l
25 EM
27 105 ESC i
Decima ASCII
l
26 SUB
27 109 ESC m
Decim ASCII
al
27 7 ESC BEL
Decimal ASCII
27 20 n ESC DC4 n
Value of n
Receipt (Pitch)
1-44 (Standard)
September 1997
Chapter 6: Commands
Value of n
Slip (Pitch)
1-66 (Standard)
63