Installing The Usb Printer Drivers; Load From Ncr Lpin D370-1111-0100; Installing The Drivers - NCR 7158 Owner's Manual

8-12 Chapter 8: Universal Serial Bus

Installing the USB Printer Drivers

Installing the Drivers

You must have LPIN D370-1111-0100 To install the required drivers to
support the USB printers
Note: NT users should exit out of all Windows programs before
starting installation.

Load from NCR LPIN D370-1111-0100

1. Insert disk into the host.
2. Double click on the Drivers icon.
1. Follow the on-screen instructions.
Warning: When instructed to connect the USB cable from the host to
the printer, be careful to plug it into the USB Board connector only.
Do not insert the USB cable into the Cash Drawer connector on the
right back of the printer. Damage to the printer could occur. If you
are not sure of your printer configuration, contact NCR before
proceeding.
Cash Drawer
Connector
CAUTION:
DO NOT plug the
USB Cable into
the Cash Drawer
Connector.
Note: Windows NT users will need to be running Service Pack 3 or
higher for a successful installation.
1. Verify that the printer is plugged in and the power is on.
DIP Strain
Relief
Switches
Communication
Power
Supply Connector
Connector (9-pin Connector)
USB
Connector
Back of
Printer