Select Or Cancel User-Defined Character Set - NCR 7158 Owner's Manual

7-58 Chapter 7: Programming Guide
Related Information:
The bits in this command perform the same function as the standalone
functions:
1B 16 n Select Pitch
1B 45 n Emphasized
12 Double-wide
13 Single-wide
1B 2D n Underline

Select or Cancel User-Defined Character Set

ASCII:
Hexadecimal:
Decimal:
Value of n: 0= Code Page 437
1= User-defined (RAM character set) with Code
Page 437 as the basis
2= Code Page 850
3= User-defined (RAM character set) with Code
Page 850 as the basis
Range: 0 - 3
Default: 0 (Code Page 437)
Selects either the Code Page 437 character set, the Code Page 850
character set, or the User-Defined character set. If the User-Defined
character set is selected, this command also designates whether the
Code Page 437 character set or the Code Page 850 character set is used
as the basis for the User-Defined character set. When you define a
character set, you do not have to define every character - the characters
from the designated basis character set are used for any undefined
characters. See the Printing Specification Guide for the character sets.
Exceptions:
Different character sets cannot be used together on the same line.
ESC % n
1B 25 n
27 37 n