Select Page Mode - NCR 7158 Owner's Manual

7-122 Chapter 7: Programming Guide

Select Page Mode

ASCII:
Hexadecimal:
Decimal:
Switches from Standard Mode to Page Mode. After printing has been
completed either by the Print and Return to Standard Mode (FF)
command or Select Standard Mode (1B 53) the printer returns to
Standard Mode. The developed data is deleted after being printed.
This command sets the position where data is buffered to the position
specified by Select Print Direction in Page Mode (1B 54) within the
printing area defined by Set Print Area in Page Mode (1B 57).
This command switches the settings for the following commands
(which values can be set independently in Standard Mode and Page
Mode) to those for Page Mode.
1. Set Right-Side Character Spacing (1B 20)
2. Select 1/6-Inch Line Spacing (1B 32)
3. Set Line Spacing (1B 33)
It is possible only to set values for the following commands in Page
Mode. These commands are not executed.
4. Select or Cancel 90 Degree Clockwise Rotation (1B 56)
5. Select Justification (1B 61)
6. Select or Cancel Upside-Down Printing (1B 7B).
7. Set Left Margin (1D 4C)
8. Set Print Area Width (1D 57)
Exceptions:
The command is enabled only when input at the beginning of a line.
The command is available only when the receipt is selected by Select
Paper (1B 63 30). The command has no effect if Page Mode has
previously been selected. The Select Paper (1B 63 30) command can not
be used in Page Mode. In A756 Emulation Mode, (1B 4C...) is used for
double density graphics.
ESC L
1B 4C
27 76