Initialize Printer; Set Slip Paper Eject Length - NCR 7158 Owner's Manual

7-26 Chapter 7: Programming Guide

Initialize Printer

ASCII:
Hexadecimal:
Decimal:
Default:
Character Pitch
Column Width
Extra Dot Rows
Character Set
Printing Position
Clears the print line buffer and resets the printer to the default settings
for the startup configuration (refer to Default settings above.)
Single-Wide, Single-High, Non-Rotated, and Left-Aligned characters
are set and User-defined characters or logo graphics are cleared (Flash
Memory is not affected). Tabs reset to default. Receipt selection state is
selected.
Exceptions:
In printers with the Parallel interface, this command also returns paper
exhaust to the paper status line if an alternate status has been
requested.

Set Slip Paper Eject Length

ASCII:
Hexadecimal:
Decimal:
Value of n :
This command is ignored.
ESC @
1B 40
27 64
Receipt
15.6 CPI
44 characters
2
Code Page 437
Column One
ESC C n
1B 43 n
27 67 n
0 to 255
Slip
13.9 CPI
66 characters
3
Code Page 437
Column One