Select Sensors To Stop Printing; Enable Or Disable Panel Buttons - NCR 7158 Owner's Manual

7-30 Chapter 7: Programming Guide

Select Sensors to Stop Printing

ASCII:
Hexadecimal:
Decimal:
Value of n :
Bit of n
Bit
Bit 0, 1
Bit 4
Bit 5
Default: 0
Determines which sensor stops printing on the respective station. The
command does not affect the paper out sensor on the receipt station,
which will automatically stop the printer when the paper is depleted.

Enable or Disable Panel Buttons

ASCII:
Hexadecimal:
Decimal:
Value of n :
Default:
Enables or disables the Paper Feed Button. If the last bit is 0, the Paper
Feed Button is enabled. If the last bit is 1, the Paper Feed Button is
disabled.
Related Information:
Functions that require using the Paper Feed Button (except for the
Execute Macro [10 5E] command) cannot be used when it is disabled
with this command.
ESC c 4 n
1B 63 34 n
27 99 52 n
Function
Stop Receipt on Receipt Low
Stop Slip if Trailing Edge Uncovered
Stop Slip if Leading Edge Uncovered
ESC c 5 n
1B 63 35 n
27 99 53 n
0 = Enable
1 = Disable
0 (Enable)