Select Paper Sensors To Output Paper End Signals (Parallel Only) - NCR 7158 Owner's Manual

Select Paper Sensors to Output Paper End Signals (Parallel
Only)
ASCII:
Hexadecimal:
Decimal:
Value of n :
If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as
the paper sensor outputting paper-end signals.
If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the
paper sensor outputting paper-end signals.
Bit Position
0 Off
On
1 Off
On
2 Off
On
3 Off
On
4, 5, 6, 7 -
Range of n :
Default:
Specifies the paper sensor to output a paper end signal. Multiple
sensors may be selected to signal when paper has run out. When
multiple sensors have been selected, anytime one of the sensors detects
a paper end, the paper end signal is output.
When this command is executed a sensor is switched. The paper end
signal switching is delayed depending on the receive buffer state.
ESC c 3 n
1B 63 33 n
27 99 51 n
Hex Decimal
00 0
01 1
00 0
02 2
00 0
04 4
00 0
08 8
- -
1 - 255
15
Chapter 7: Programming Guide 7-29
Function
Paper roll near end sensor disabled
Paper roll near end sensor enable
Paper roll near end sensor disabled
Paper roll near end sensor enabled
Paper roll end sensor disabled
Paper roll end sensor enabled
Paper roll end sensor disable
Paper roll end sensor enabled
Undefined