Full Knife Cut; Partial Knife Cut; Generate Tone; Set Column - NCR 7193 Owner's Manual

7193 Owner's Guide
Print
Prints one line from the buffer and feeds paper one line.
Hexadecimal
17

Full Knife Cut

This command is implemented the same as Partial Knife Cut (1A/1B 6D).
Hexadecimal
19
1B 69

Partial Knife Cut

Partially cuts the receipt, leaving .20 inch (5 mm) of paper. The length of the cut can be
changed through the DIP switches. See "Setting Partial Cut Distance" in chapter 4. The cut
edge is 108 dot rows or .71 inch (18 mm) above the print station. It is valid only at the
beginning of a line.
Hexadecimal
1A
1B 6D

Generate Tone

Generates an audible tone.
Hexadecimal
1B 07

Set Column

Prints the first character of the next print line in column n. It must be sent for each line not
printed at column one. The value of n is set to one after each line. It cannot be used with
Single- or Double-Density graphics.
Hexadecimal
1B 14 n

Set Character Right-Side Spacing

This command is not implemented and is ignored if received.
Hexadecimal
1B 20 n
Decimal ASCII
23 ETB
Decimal ASCII
25 EM
27 105 ESC i
Decimal ASCII
26 SUB
27 109 ESC m
Decimal ASCII
27 7 ESC BEL
Decimal ASCII Value of n
27 20 n ESC DC4 n 1-44 (Standard Pitch)
1-56 (Compressed pitch)
Decimal ASCII
27 32 n ESC (SPACE) n
August 1998
Chapter 6: Commands
49