Set Character Right-Side Spacing - NCR 7158 Owner's Manual

7-56 Chapter 7: Programming Guide

Set Character Right-Side Spacing

ASCII:
Hexadecimal:
Decimal:
Range of n:
Default :
Sets the right side character spacing to [n x horizontal or vertical
motion units]. Values for this command are set independently in
Standard and Page Mode.
The units of horizontal and vertical motion are specified by the Set
Horizontal and Vertical Minimum Motion Units (1D 50...) command.
Changes in the horizontal or vertical units do not affect the current
right side character spacing. When the horizontal or vertical motion
unit is changed by the Set Horizontal and Vertical Minimum Motion
Units (1D 50...) command the value must be in even units and not less
than the minimum amount of horizontal movement.
In Standard Mode the horizontal motion unit is used.
In Page Mode the horizontal or vertical motion unit differs and
depends on the starting position of the printable area. When the
starting printing position is the upper left or lower right of the
printable area (set by Select Print Direction in Page Mode, 1B 54 n) the
horizontal motion unit (x) is used. When the starting printing position
is the upper right or lower left of the printable area (set by Select Print
Direction in Page Mode, 1B 54 n) the vertical motion unit (y) is used.
Exception:
This command is ignored in A756 Emulation Mode and is only valid
on the receipt station.
ESC SP n
1B 20 n
27 32 n
0 - 32
0