Basic settings
5.2.5
Perform frequency setting by analog current input
● Pr. 79 "Operation mode selection" must be set to "4" (external/PU combined operation
mode 2).
● Use the FWD or REV key to give a start command.
Fig. 5-24: Frequency setting by analog current input
NOTE
Turn the AU signal on to activate the analog current input (0/4 to 20mA). Use a jumper or the
like as shown in Fig. 5-24.
FR-A700 EC
Power
supply
AU signal
Output of the
adjustment meter
(0/4 to 20mADC)
PU operation mode
Inverter
Motor
I001078E
5 - 47