Mitsubishi Electric FR-A700 Instruction Manual page 480

Function assignment of external terminals
Setting
Terminal Function
Source Sink
Logic Logic
33 133 RY2
34 134
35 135 TU
36 136 Y36
39 139 Y39
41 141 FB
42 142 FB2
43 143 FB3
44 144 RUN2
45 145 RUN3
46 146 Y46
47 147 PID
Tab. 6-86: Output terminal function assignment (3)
6 - 300
Operation ready 2
LS Low speed output
Torque detection
In-position
Start time tuning completion
Speed detection
Second speed detection
Third speed detection
Inverter running
During inverter running and start
command is on
During deceleration at occur-
rence of power failure (retained
until release)
During PID control activated
Operation
Output during pre-exitation or
operation under real sensor-
less vector control.
Output when the output fre-
quency reduces below the
Pr. 865 setting.
Output when the motor torque
rises above the Pr. 864 value.
Output when the number of
droop pulses has fallen below
the setting value.
Output on completion of start-
time tuning.
Output when the actual motor
speed (estimated actual
speed value) reaches the Pr.
42 (Pr. 50, Pr.116) setting.
Output during forward
rotation or the reverse
rotation signal is ON.
Output at deceleration
even during forward
rotation or the reverse
rotation signal is OFF.
(Does not output during
pre-excitation LX is ON.)
Output during the
orientation command
signal (X22) is ON.
Switched ON when the
servo is ON (LXON)
under position control.
(Switched OFF when tne
servo is OFF (LX-OFF))
Output when the inverter run-
ning and start commands are
on.
Output when the power fail-
ure-time deceleration function
is executed.
Output during PID control.
Parameter
Related Parame- Refer to
ters Page
— 6-304
Pr. 865 6-309
Pr. 864 6-314
Pr. 426 6-140
Pr. 95, Pr. 574 6-236
Pr. 42, Pr. 50,
6-309
Pr. 116
— 6-303
— 6-303
Pr. 261–Pr. 266 6-346
Pr. 127–Pr. 134,
6-488
Pr. 575–Pr. 577