Rep 2.10 Tray 1 Feed Roll; Rep 2.11 Tray 1 Retard Holder Assembly - Xerox DocuPrint N2025 Service Manual

REP 2.10 Tray 1 Feed Roll

Parts List on PL 4.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the MBF Assembly (REP 2.1).
2. Turn the MBF up-side down.
3. Release the Tray 1 Feed Solenoid.
4. Rotate the Feed Rolls up.
5. Press locking tab that secures the Left Roll Core (Figure 1).
6. Slide the Left Roll Core to the left (Figure 1).
7. Slide the Feed Roll to the left and remove (Figure 1).
8. If replacing the envelope feed rolls, press the locking tabs and remove the two envelope
feed rolls (Figure 1).
Figure 1 Tray 1 Feed Roll
Replacement
1. Reinstall the components in the reverse order. Note the arrows on the side of the enve-
lope feed rolls. The arrows indicate the direction of rotation.
NOTE: Note the arrows on the side of the envelope feed rolls. The arrows indicate the
direction of rotation.
Initial Issue
DocuPrint N2025/N2825
WARNING

REP 2.11 Tray 1 Retard Holder Assembly

Parts List on PL 3.1
Removal
Switch off the power and disconnect the Power Cord.
1. Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect it from
light.
2. Remove Tray 1.
3. Remove the MBF Assembly (REP 2.1).
4. Remove the Retard Chute Assembly (REP 3.1).
5. From the rear, release the two locking tabs (Figure 1).
6. Remove the Retard Holder Assembly from the front (Figure 1).
Figure 1 Retard Holder Assembly
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-17
WARNING
Repair-Adjustment
REP 2.10, REP 2.11