Wiring Data - Xerox DocuPrint N2025 Service Manual

Figure 2 Master Wiring Diagram (2 of 2)
NOTE: *1: The Duplex Interface PWB and the components connected to it by means of P/
J503, P/J504, and P/J505 are the components of the Duplex Assembly and OCT.
Wiring and Signal Description between Components
The Master Wiring Diagram is divided into the following 12 sections. The signal names, pin
numbers, and other information are given in detailed diagrams by sections.
Organization
1. Print Engine Controller PWB<-->LVPS<-->INTER-LOCK SWITCH and FANs
2. Print Engine Controller PWB<-->FUSER ASSEMBLY, FUSER PWB
Initial Issue
DocuPrint N2025/N2825
3. Print Engine Controller PWB<-->Laser and Print Cartridge SENSOR ASSEMBLY (Print Car-
tridge SWITCH and LD SWITCH)
4. Print Engine Controller PWB<-->HVPS<-->Print Cartridge (BCR and MAG. ROLL), BTR,
and DETACK SAW
5. Print Engine Controller PWB <--> REG. CLUTCH and REG. SENSOR
6. Print Engine Controller PWB <--> FEED SOLENOID, TURN CLUTCH, NO-PAPER SEN-
SOR
7. Print Engine Controller PWB <--> LOW PAPER SENSOR, P/H UNIT, TRAY 1 PAPER SIZE
SWITCH
8. Print Engine Controller PWB <--> MAIN MOTOR
9. Print Engine Controller PWB <--> TONER SENSOR
10. Print Engine Controller PWB <--> Duplex Interface PWB <--> FULL STACK SENSOR
11. CONTROLLER <--> Control Panel
12. Print Engine Controller PWB <--> DIAGNOSTIC TOOL
02/2000
7-5

Wiring Data

Base Engine