REP 1.4 Front Cover
Parts List on PL 1.1
Removal
Switch off the power and disconnect the Power Cord.
1.
Open the Rear Cover.
2.
Remove the OCT, if installed (REP 10.1).
3.
Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect it from
light.
NOTE: Place paper inside the Print Cartridge cavity to catch any dropped hardware.
4.
Remove the Left Side Cover (REP 1.1).
5.
Remove the Top Cover Assembly (REP 1.3).
6.
Open the MBF Assembly Door, lift slightly, and pull the assembly out approximately 2
inches (51 mm).
7.
Remove the 2 screws that secure the Front Cover to the printer (Figure 1).
8.
Pull the Front Cover out then up to remove (Figure 1).
Figure 1 Front Cover
Replacement
1.
Reinstall the components in the reverse order.
2.
Align the two hooks on the Front Cover with the holes in the printer.
Initial Issue
DocuPrint N2025/N2825
WARNING
REP 1.5 Lower Left Cover
Parts List on PL 1.1
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the Left Side Cover (REP 1.1).
2.
Remove the 2 Screws that secure the Lower Left Cover to the printer (Figure 1).
3.
Remove the Lower Left Cover (Figure 1).
Replacement
1.
Reinstall the components in the reverse order.
02/2000
4-7
WARNING
Figure 1 Lower Left Cover
REP 1.4, REP 1.5
Repair-Adjustment