Xerox DocuPrint N2025 Service Manual page 340

Table 3 Pin numbers and voltage levels for the Print Engine Controller PWB <--> Fuser
Assembly path
Signal Name Description
/EXIT (TTL) Signal from the Exit Sensor. This signal is Low when the Exit Sensor is
actuated.
TEMP Temperature monitor signal (analog signal) from the Temperature Sensor
Assembly (Thermistor) that indicates the temperature of the Heat Roll sur-
face
Table 4 Signal names for the Print Engine Controller PWB <--> Fuser PWB path
Signal Name Description
/HEAT 1(TTL) Fuser control signal to switch AC power to the Heater Rod on and off Low:
On, High: Off
/HEAT 2(TTL) Fuser control signal to switch AC power to the Heater Rod on and off Low:
On, High: Off
Figure 5 Fuse, Thermostat, Heater Rod, and Thermistor specifications
Wiring Data
Base Engine
02/2000
7-10
Initial Issue
DocuPrint N2025/N2825