Offset Catch Tray - Xerox DocuPrint N2025 Service Manual

30. Print Engine Controller PWB <--> Duplex Interface PWB <--> Duplex PWB <--> Duplex
Motor Assembly, Exit Motor Assembly and Duplex Sensor Assembly
Table 2 Signal names for the Duplex Interface PWB <--> Duplex PWB path
Signal Name Description
A-CLK The signal that commands "Low" speed rotation in clockwise of the
Duplex Motor Assembly and the Exit Motor Assembly.
B-CLK The signal that commands "High" speed rotation in clockwise of the
Duplex Motor Assembly and the Exit Motor Assembly.
A-ON The signal activates the Motor, synchronizing with A-CLK signal.
B-ON The signal activates the Motor, synchronizing with B-CLK signal.
A-DIR The signal that commands the direction of rotation.
DUP-SNS The signal from the Sensor Assembly Dup. This signal is "Low" when the
paper exists in the Duplex Assembly.
Wiring Data
Duplex Assembly, Offset Catch Tray

Offset Catch Tray

Location of P/J Connectors
Use the P/J table below (Table 1) and the P/J map (Figure 1) on the next page to locate a spe-
cific P/J connector within the Feeder and Cassette.
1. Locate the P/J connector number in the first column of the table (Table 1).
2. Locate the corresponding coordinates in the second column, such as I7 or J7.
3. Go to the map (Figure 1).
4. Cross-reference the letter and number of the P/J coordinates with the letters and numbers
on the map.
5. The P/J connector is located within the area where the coordinates cross.
Connector Coordinate Description
P/J 514 E6 Connects the STK-0 Harness to the OCT PWB.
P/J 515 F7 Connects the Offset Motor Assembly to the OCT PWB.
P/J 516 J7 Connects the inside the Offset Motor Assembly.
P/J 517 F6 Connects STK Motor Harness to the OCT PWB.
P/J 518 C6 Connects the STK Motor Harness to the OCT Motor Assembly.
P/J 519 J9 Connects the Printer Assembly (Duplex I/F PWB) to the Gate
Solenoid.
P/J 520 E6 Connects the STK FLJM Harness to the OCT PWB.
P/J 521 D5 Connects the STK FLJM Harness to the Stack Full Sensor.
P/J 523 G7 Connects the STK FLJM Harness to the OCT Sensor.
P/J 524 E6 Connects the STK COV OP Harness to the OCT PWB.
P/J 525 D5 Connects the STK COV OP Harness to the Interlock Switch.
P/J 526 B8 Connects the STK-0 Harness to the Duplex I/F PWB.
02/2000
7-40
Table 1 P/J Locations
DocuPrint N2025/N2825
Initial Issue