Gp 5.11 Tray1/2/3 Assembly - Xerox DocuPrint N2025 Service Manual

GP 5.11 Tray1/2/3 Assembly

Side Guide PLT (Left and Right) - Figure 1
Can be adjusted left and right to accommodate different paper sizes. They contact the left and
right sides of the paper stack and hold the paper stack in place in the left and right direction.
The Side Guide PLT L and R are able to move together smoothly by pushing down the Lever
side R to the positions where they hold the left and right corners of the front end of the paper
stack.
End Guide -
Can be adjusted in the front and rear direction to accommodate different paper sizes. It con-
tacts the back (far side) of the paper stack and holds the paper stack in place in the front and
rear direction.
When the Guide End is moved to come into contact with the rear side of paper stack, the Cam
Size at the left side of the Cassette Assembly turns to the position in which it presses the Actu-
ators Size of the feeder with a pattern of projections corresponding to the paper size. The
depressed Actuators Size in turn actuate the Switches Size. The size of the paper loaded in
the Cassette Assembly is thus detected by the pattern of actuated Switches Size.
The Cam Size has different patterns of projections predetermined for the sizes of paper the
Cassette Assembly can hold.
Bottom Plate -
The force pressing up the Plate Bottom is provided by the three springs. The Plate Bottom is
pressed up by these springs to ensure the contact with paper to be fed and the Feed Roll of the
Tray Feed Assembly.
Figure 1 Cassette Assembly
General Procedures / Information Initial Issue
02/2000
GP 5.11
6-64 DocuPrint N2025/N2825