GP 5.7 Drive Power Transmission to the Turn Roll
Assembly
The drive power generated by the Motor: Main is transmitted to the Turn Clutch Assembly of
the Turn Roll Assembly through the Gear Assembly: Main, the Gear MBF IN, the Gear Idle
MBF 1, and the Gear Idle MBF 2 Figure 1.
When the Turn Clutch Assembly is activated, the drive power in transmitted through the Turn
Clutch Assembly to the Gear Turn and the Rolls on the same shaft as the Turn Clutch Assem-
bly are put on. Figure 2.
Figure 2 Drive to Feed Roll Assembly
Figure 1 Drive to Turn Roll Assembly
General Procedures / Information
Initial Issue
02/2000
GP 5.7
6-60
DocuPrint N2025/N2825