Rep 10.1 Offset Catch Tray (Oct); Rep 10.2 Top Cover - Xerox DocuPrint N2025 Service Manual

REP 10.1 Offset Catch Tray (OCT)

Parts List on PL 10.1
Removal
Switch off the power and disconnect the Power Cord.
1. Open the printer Rear Cover.
2. Loosen the thumb screw located on the inside of the right frame (Figure 1).
3. Lift the Offset Catch Tray (OCT) straight up and remove (Figure 1).
4. Remove OCT Solenoid Assembly (REP 10.5) if removal is permanent.
Figure 1 Offset Catch Tray
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2025/N2825
WARNING

REP 10.2 Top Cover

Parts List on PL 10.1
Removal
Switch off the power and disconnect the Power Cord.
1. Open the OCT Rear Cover.
2. Remove the OCT Output Catch Tray.
3. Remove the four screws that secure the Top Cover (Figure 1).
4. Lift the cover up to remove (Figure 1).
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-55
WARNING
Figure 1 OCT Top Cover
REP 10.1, REP 10.2
Repair-Adjustment