REP 2.4 Tray 1 Turn Roll Assembly
Parts List on PL 3.1
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the MBF Assembly (REP 2.1).
2.
Remove the MBF Gear Cover (REP 1.8).
3.
Remove the Turn Roll Clutch (REP 2.3).
4.
Remove the bearing located behind the Turn Roll Clutch (Figure 1).
5.
Remove the E-Ring from the right end of the Turn Roll Assembly (Figure 1).
6.
Remove the bearing from the right end of the Turn Roll Assembly Shaft (Figure 1).
7.
Remove the Turn Roll Assembly (Figure 1).
Figure 1 Tray 1 Turn Roll Assembly
Replacement
1.
Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2025/N2825
WARNING
REP 2.5 MBF Retard Holder Assembly
Parts List on PL 3.1
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the MBF Assembly (REP 2.1).
2.
Remove the MBF Gear Cover (REP 1.8).
3.
Remove the Pick-up Spring from the MBF Pick-up Gear (Figure 1).
4.
Release the two locking tabs on the MBF Pick-up Gear and remove the gear (Figure 1).
5.
Move the MBF Pick-up Shaft to the right and remove the shaft from the MBF (Figure 1).
6.
Remove the screw that secures the support bracket to the MBF (Figure 1). Remove the
bracket.
7.
Insert a screwdriver between the left side of the MBF and the MBF Tray Assembly near
the tray pivot point (Figure 2). Carefully spread the two assemblies until the tray disen-
gages from the MBF.
8.
Release the two locking tabs on the back of the retard holder and rotate the retard holder
forward (Figure 3).
9.
Continue to rotate the holder forward until it can be lifted out of the MBF base (Figure 3).
Figure 1 MBF Pick Up Shaft
02/2000
4-13
WARNING
Repair-Adjustment
REP 2.4, REP 2.5