Gp 2.5 2000 Sheet Feeder Specifications - Xerox DocuPrint N2025 Service Manual

GP 2.5 2000 Sheet Feeder Specifications

Contents
1. Specifications
1.1 Equipment Components
1.1.1 Basic Components
1.2 Electrical Characteristics
1.2.1 Power Supply
1.3 Mechanical Characteristics
1.3.1 Dimensions and Weight Table 1.
1.4 Paper
1.4.1 Paper Size
1.4.2 Supported Paper
1.4.3 Maximum Paper Stacking Ability
1.5 Replacement Parts
1.6 Environment
1.6.1 Noise Level
1. Specifications
1.1 Equipment Components
1.1.1 Basic Components
The 2000 Sheet Feeder Assembly is connected to the bottom of the N2025/N2825 base
engine or 500 Sheet Feeder 2 with stud pins (2), screws (2) and a drawer connector.
1.2 Electrical Characteristics
1.2.1 Power Supply
24V DC and 3.3V DC are supplied from the Print Engine Controller PWB directly or through
the PWB Feeder 2.
General Procedures / Information
GP 2.5
1.3 Mechanical Characteristics
1.3.1 Dimensions and Weight Table 1.
Table 1 Dimensions and Weight
Width
Depth
Height
Weight
1.4 Paper
1.4.1 Paper Size
You can use the following paper size in the 2000 Sheet Feeder.
• A4 (LEF)
• LETTER (8.5"x11" LEF)
1.4.2 Supported Paper
64gsm ~ 200gsm
1.4.3 Maximum Paper Stacking Ability
2000 sheets (Xerox 4024 DP 20 lb(75gsm), RX, or FX L(64gsm))
1.5 Replacement Parts
The 2000 Sheet Feeder does not have any components that need to be regularly replaced.
Replace the following components as needed when they are worn out.
• Roll Assembly
1.6 Environment
1.6.1 Noise Level
During printing: 53.0 dB (Print Engine +500 Sheet feeder + 2000 Sheet Feeder) 53.0 dB (Print
Engine +500 Sheet feeder + Duplex + 2000 Sheet Feeder)
02/2000
6-18
Unpacked
490 mm
509 mm
428 mm
19.0 kg
DocuPrint N2025/N2825
Initial Issue