Registration (Lead Edge To Trail Edge); Skew - Xerox DocuPrint N2025 Service Manual

Registration (Lead Edge to Trail Edge)

Procedure
Measure the registration on two consecutive System Controller Test Patterns. Fold the paper in
half (lead edge to Trail Edge). Observe the fold line of the paper with reference to the cross
hairs of the target. The fold is within +/- 2.0 mm of the target cross hairs (each line on the
target is 1 mm) (Figure 1).
Y N
Go to IQ RAP 15 Registration.
The printed test patterns meet the lead edge to trail edge registration specification. Go to

Skew.

Figure 1 Registration (Lead Edge to Trail Edge).
Image Quality Repair Analysis Procedures
Registration, Skew
Skew
Procedure
Enter Diagnostics and select Test Print. Scroll to Print Pattern and press Enter [4]. Observe the
test pattern. Measure the dimensions 'A' and 'B' (Figure 1) on two consecutive test patterns.
The difference between 'A' and 'B' should be 1.5 mm or less. The skew on the test patterns
meets the specification.
Y N
Go to IQ RAP 13 Skewed Image.
The printed test patterns meet the Skew specification. Go to the Skips and Smears.
Figure 1 Printer Engine Controller Test Pattern.
02/2000
3-8
Initial Issue
DocuPrint N2025/N2825