REP 5.4 Exit Gate Chute
Parts List on PL 6.1
Removal
Switch off the power and disconnect the Power Cord.
1.
Open and remove the Rear Cover (REP 1.9).
2.
Remove the four screws that secure the Lower Exit Chute Assembly (Figure 1). Remove
the assembly.
3.
Note the position of the gate spring. Unhook the gate spring (Figure 2).
4.
Carefully bend the Exit Gate in the middle until the left end is free of the Rear Cover (Fig-
ure 2).
5.
Align the tab on the Gate with the hole in the Rear Cover. Remove the chute (Figure 3).
6.
Remove the spring from the chute (Figure 3).
Figure 1 Lower Exit Chute
Initial Issue
DocuPrint N2025/N2825
WARNING
Replacement
1.
Reinstall the components in the reverse order.
02/2000
4-31
Figure 2 Exit Gate Spring
Figure 3 Exit Gate
Repair-Adjustment
REP 5.4