Ip Arp Inspection Trust; Ip Arp Inspection Limit - NETGEAR ProSafe M7100-24X User Manual

no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Format
no ip arp inspection vlan vlan-list logging
Mode
Global Config

ip arp inspection trust

Use this command to configure an interface as trusted for Dynamic ARP Inspection.
Default
enabled
Format
ip arp inspection trust
Mode
Interface Config
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
Format
no ip arp inspection trust
Mode
Interface Config

ip arp inspection limit

Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means the interface is not rate limited for Dynamic ARP
Inspections.
Note: The user interface will accept a rate limit for a trusted interface, but
the limit will not be enforced unless the interface is configured to be
untrusted.
Default
15 pps for rate and 1 second for burst-interval
Format
ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
141