Show Ipv6 Pim; Ipv6 Pim Hello-Interval - NETGEAR ProSafe M7100-24X User Manual

ipv6 pim hello-interval

Use this command to configure the PIM hello interval for the specified router interface. The
hello-interval is specified in seconds and is in the range 10–18000.
Default
30
Format
ipv6 pim hello-interval <10-18000>
Mode
Interface Config
no ipv6 pim hello-interval
Use this command to set the PIM hello interval to the default value.
Format
no ipv6 pim hello-interval
Mode
Interface Config

show ipv6 pim

Use this command to display PIM Global Configuration parameters and PIM interface status.
Format
show ipv6 pim
Mode
• Privileged EXEC
• User EXEC
Term Definition
PIM Mode
Configured mode of PIM protocol
Data Threshold Rate
Rate (in kbps) of SPT Threshold
Register Rate-limit
Rate (in kbps) of Register Threshold
Interface
Valid unit, slot, and port number separated by forward slashes
Interface-Mode
Indicates whether PIM-DM is enabled or disabled on this interface
Operational-Status
The current state of PIM-DM on this interface. Possible values are Operational or
Non-Operational.
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pim
PIM Mode..................................... Dense
Data Threshold Rate (Kbps)................... 0
Register Rate-limit (Kbps)................... 0
Interface Interface Mode
--------- --------------
1/0/1 Enabled
ProSafe Managed Switch
Operational-Status
----------------
Non-Operational
IPv6 Multicast Commands
421